If you have a security-equipped Harley-Davidson, you know that without your key fob present, the bike will not start. What you should also know is your PIN number, just in case you lose your key.
Programming a remote for your Harley-Davidson motorcycle's alarm remote does not require a trip to your local technician, or to the Harley dealership. As long as you have the key, you can do the remote's programming on your own. It involves a combination of setting the ignition bezel back and forth in the correct positions, pressing the turn signals and pushing the remote's buttons at the right time. If you haven't attempted to program your Harley's remote yourself before, do not get flustered. With proper instruction, it can be programmed in less than five minutes of your time.
Step 1
Turn the key in the ignition to 'Off,' then complete the following steps with less than 10 second pauses in between them. The vehicle should be disarmed, which can be verified by the fact that there are no blinking lights.
Step 2
Turn the key in the ignition to 'On,' 'Off,' 'On,' 'Off,' then back to the 'On' position.
Step 3
Press the left turn signal switch for a total of two times. Wait for the lights to blink one to three times in response, depending on the configuration of your motorcycle's system.
Step 4
Press the right turn signal once, release it, then wait for the signals and indicators to flash once.
Step 5
Press the left turn signal switch, then release it. Two flashes from the signals and indicators will be seen.
Step 6
Hold down the button on the remote that you wish to program to the transceiver until two flashes are seen coming from the signal and indicator lights on your motorcycle. You should receive this confirmation within 10 to 25 seconds. Repeat for any additional buttons at this time as well.
Turn the key back to 'Off,' then take it out of the bezel. Your fob remote is now synced to the Harley's transceiver system.
- une harley image by Géraldine Royer from Fotolia.com
More Articles
Your Harley came with a key fob. If for some reason you do not have the key fob present, but you do have the key, you will need to have reset the factory alarm with your own personal identification number. Changing the personal identification number will allow you to start your Harley when you do not have the key fob, or even if the battery in key fob has not been changed. Without resetting your alarm, your Harley will only be a pretty lawn ornament.
Resetting Your PIN
Step 1
Select a five-digit number and record it in the manual or some place else easily accessible in case you forget it.
Step 2
With an assigned fob present, turn the 'IGN' key in this pattern: Ignition-Off-Ignition-Off-Ignition.
Step 3
Step 4
Press the right turn signal one time and release. The turn signal should flash three times. The current PIN number should appear in the odometer. The first digit will be flashing.
Step 5
Enter the first number by pressing the left turn signal the same number of times as the digit. So if the first number is 5, press the left turn signal five times.
Step 6
Press the right turn signal one time and release. The new number will replace the old number in the odometer.
Step 7
Repeat steps 5 and 6 until all numbers have been reset.
Disarming with Your PIN
Step 1
Step 2
Hold both turn signal switches until you receive confirmation.
Step 3
Enter the first number by pressing the left turn signal the same number of times as the digit.
Step 4
Repeat steps 3 and 4 until you have entered your PIN.
Tip
- Your key fob will automatically disarm your alarm.
- motorcycle 2 image by Vitezslav Halamka from Fotolia.com